neocube Operating and installation instructions - model S

5

External combustion air connection (Ø 125 mm)

If an external combustion air connection is required, this can either be connected at the rear or at the bot- tom. In the case of a connection at the rear, this must be connected through the steel rear panel (see figure 1). In the case of a connection at the bottom, feed the AluFlex pipe through the centre of the base plate (see figure 2).

Bild 1

Bild 2

6

Installing the baffle plate

Mount the baffle plates as shown in the illustrations.

7

Aligning the heating insert

After all the connections and baffle plates have been mounted, place the heating insert into the water, using a spirit level to adjust the feet. When doing so, check the alignment at the front and sides (see illustrations).

8

Installing the lower ceramic element

Carefully lift the lower ceramic element onto the base plate and push back evenly. Position it so that the ele- ment is flush with the frame to the left, right and front.

neocube S – Operating and installation instructions

13