neocube Operating and installation instructions - models P/C

4

Change design

As standard, all neocube models are supplied in design type 1 (self-closing). If you wish to change to design type 2, the supplied additional weights and washers must be installed on the exis- ting weight (remove washers – mount weights – fix in place with washers).

5

Twist the screws down

OPTIONAL removing the lock nuts

Twist the 6 adjustment screws down using a size 8 open-end wrench until they fit flush with the base plate.

If the adjustable feet are completely screwed in, the gap between the floor and the cladding is approx. 40 mm – this gap can also be reduced by approx. 12 mm by removing the 4 lock nuts.

Removing the lock nuts can cause wobbling at a later stage.

neocube P / C – Operating and installation instructions

16